Rohde & Schwarz Scope Rider RTH1004 - Page 451

Remote Control Commands
R&S
®
Scope Rider RTH
451User Manual 1326.1578.02 ─ 12
BUS:CAN:TYPE <SignalType>
Selects whether the chip select signal is high active (high = 1) or low active (low = 1).
Parameters:
<SignalType> CANH | CANL
CANH
Signal is high active (high = 1).
CANL
Signal is low active (low = 1).
*RST: CANL
BUS:CAN:BITRate <CustomBitrate>
Sets the number of transmitted bits per second.
Parameters:
<CustomBitrate> Range: 10000 to 1000000
Increment: 1
*RST: 50000
Default unit: bps
BUS:CAN:TECHnology <ThresholdType>
Parameters:
<ThresholdType> TTL | ECL | CMOS | CAN | GND | LIN7vsupply | LIN12vsupply |
LIN18vsupply | USER
TTL
1.4 V
ECL
-1.3 V
CMOS
2.5 V
GND
0 V (for CAN channels, requires option R&S RTH-K3)
CAN
2 V (for CAN channels, requires option R&S RTH-K3)
LIN7vsupply | LIN12vsupply | LIN18vsupply
7 V / 12 V / 18 V (for LIN channels, requires option R&S RTH-
K3)
USER
Set the value with CHANnel<m>:THReshold:USER.
*RST:
CAN
Protocol Analysis