Rohde & Schwarz Scope Rider RTH1004 - Page 87

Waveform Analysis
R&S
®
Scope Rider RTH
87User Manual 1326.1578.02 ─ 12
●
CURSor:Y1Position on page 340
●
CURSor:Y2Position on page 340
●
CURSor:DELTa? on page 340
Track cursors
Two vertical cursor lines are coupled to the waveform. The instrument measures the
vertical values y1 and y2 of the crossings between the cursor lines and the waveform.
It also measures the absolute values of the difference between the positions Δy and of
the time difference between the cursor lines Δt
●
CURSor:Y1AMplitude? on page 341
●
CURSor:Y2AMplitude? on page 341
●
CURSor:DELTa? on page 340
●
CURSor:TDELta? on page 340
Measurements
Two vertical cursor lines define a gate for two parallel automatic measurements. All
automatic measurements that need only one source are available. Delay, phase, and
power measurements are not provided for cursor measurements, they require two
sources.
See Chapter 4.2.3, "Measurement Types", on page 80.
If the measurement result is outside the measurement range and clipping occurs, the
results are marked with < (underflow) or > (overflow). Adjust the vertical scale to get
valid results.
●
CURSor:MEASurement<m>:RESult:ACTual? on page 341
●
CURSor:MEASurement<m>:RESult:LIMit? on page 341
4.3.3 Settings for Cursor Measurements
Access: "Cursor" menu
Cursor Measurements