Waveform Analysis
R&S
®
Scope Rider RTH
93User Manual 1326.1578.02 ─ 12
Remote command:
REFCurve:STATe on page 343
CALCulate:MATH:STATe on page 342
Vertical Position
Sets the vertical position of the reference waveform.
You can also tap the waveform label "R" to set the focus to the reference waveform,
and use the [RANGE] and [POS] keys to adjust the display.
Remote command:
REFCurve:POSition on page 343
Save/ Load
Saves or loads a reference waveform. The default directory is C:/Users/<user>/
Rohde-Schwarz/RTH/ReferenceCurves.
Select the "File Type" (format BIN, XML, or CSV) and enter the "File Name". See also
Chapter 4.5.2, "Waveform Files", on page 93.
Remote command:
REFCurve:NAME on page 344
REFCurve:SAVE on page 344
REFCurve:OPEN on page 344
REFCurve:DELete on page 344
4.5.2 Waveform Files
Reference waveforms can be stored in XML, CSV, or BIN format.
If you want to reload reference waveforms on the instrument, save them in BIN or CSV
format. XML files cannot be reloaded.
Waveform data is saved in two files. One file contains the waveform data values and is
indicated by *Wfm.* in the file name. The second file contains the header data, for
example, time scale, vertical scale, vertical position, acquisition mode, and more.
Header data is required to reload the waveform from data, or to analyze the data val-
ues of the data file.
4.5.2.1 Waveform Header Files
The header files of XML and BIN waveform files are written in XML format. The header
files of CSV waveform files are written in CSV format. You can open the header files
and use their information for data analysis.
CSV header files only contain the property names and values, one property per row.
VerticalScale:0.05:
HorizontalScale:5e-08:
Reference Waveforms
To Next Page
Loading...
