R&S SMB List Mode
1407.0806.32 4.55 E-2
The menu is used to activate/deactivate operating mode List, to create, select and activate the lists, and
to select the trigger mode and the dwell time.
State - List Mode
Activates/deactivates the LIST mode. The currently selected list is
processed.
In case of a new or modified list, the necessary hardware settings are
automatically determined on activation of the list mode. The data
determined in this way is stored along with the list and is available
whenever the list is used again.
This means that when activating the list mode, the system checks
whether any hardware settings are present. If so, the list is started
immediately, but if not they are automatically determined (the list is
learnt).
A Learn List Mode Data button is available for deliberately activating
list learning.
Note:
Activating the list mode automatically deactivates all sweeps.
During list mode the frequency and level indications are dimmed,
they do not display the currently set values.
Remote-control command:
SOUR:FREQ:MODE LIST
Mode - List Mode
Selects the cycle mode of the LIST mode.
Auto
Cycle from the beginning to the end of the list with
automatic restart at the beginning.The duration of a
list step is determined by the set dwell time. Button
Reset restarts the list at the starting point.
Remote-control commands:
SOUR:FREQ:MODE LIST
SOUR:LIST:MODE AUTO
SOUR:LIST:TRIG:SOUR AUTO
To Next Page
Loading...
