List Mode R&S SMB
1407.0806.32 4.56 E-2
Single
Single cycle from the beginning to the end of the list.
If Single is selected, the cycle is not started
immediately. The Execute Single button appears
under the Mode line. The cycle is started with this
button. The duration of a list step is determined by
the set dwell time. Button Reset restarts the list at
the starting point.
Remote-control commands:
SOUR:FREQ:MODE LIST
SOUR:LIST:MODE AUTO
SOUR:LIST:TRIG:SOUR SING
SOUR:LIST:TRIG:EXEC
Step
Manual, step-by-step processing of the list.
Activating Step stops the current list and the cursor
moves to the value displayed for Current Index. It is
now possible to scroll up and down in the list in
discrete steps by varying the index or to enter a
freely selectable index. The duration of a list step is
determined by the time between two index entries.
Remote-control commands: n.a.
(only external step mode is available in remote
control)
Extern Single
Single cycle from the beginning to the end of the list
as with Single, but started by an external trigger.
Button Reset restarts the list at the starting point.
The external trigger signal is input at the BNC
connector INST TRIG on the rear of the instrument.
Remote-control commands:
SOUR:FREQ:MODE LIST
SOUR:LIST:MODE AUTO
SOUR:LIST:TRIG:SOUR EXT
Extern Step
Step-by-step cycle using the external trigger signal.
Each trigger event starts a single step. The list is
processed in ascending order. The duration of a list
step is determined by the time between two trigger
events. Button Reset restarts the list at the starting
point.
The external trigger signal is input at the BNC
connector INST TRIG on the rear of the instrument.
Remote-control commands:
SOUR:FREQ:MODE LIST
SOUR:LIST:MODE STEP
SOUR:LIST:TRIG:SOUR EXT
(external trigger)
To Next Page
Loading...
