R&S SMB List Mode
1407.0806.32 4.57 E-2
Execute Single - List Mode
(Mode Single only)
Triggers the list manually. This button is available only if Mode Single
is selected.
Remote-control commands
SOUR:FREQ:MODE LIST
SOUR:LIST:MODE AUTO
SOUR:LIST:TRIG:SOUR SING
SOUR:LIST:TRIG:EXEC
Reset - List Mode
Resets the list to the starting point.
Remote-control command:
SOUR:LIST:RES
Dwell Time - List Mode
Enters the dwell time. The dwell time determines the duration of a list
step in list operating modes Auto, Single and Extern Single. In these
modes a complete list is processed either once or continuously.
In list operating modes Step and Extern Step, the set dwell time does
not affect signal generation. In this case, the duration of a list step is
determined by the time between two (internal or external) trigger
events.
Remote-control command:
SOUR:LIST:DWEL 10 ms
Current Index - List Mode
Sets the list index in Step mode.
Remote-control command: n.a.
Blank RF Output (Default
ON) - List Mode
Activates/deactivates RF output blanking. If activated, blanking occurs
on all frequency changes. If deactivates, blanking is always disabled.
Remote-control command:
OUT:BLAN:LIST:STAT ON
Learn List Mode Data... -
List Mode
Starts the determination of the hardware setting for the selected list.
The data determined in this way is stored along with the list.
It may be necessary to deliberately activate list learning in the event of
greatly altered environmental conditions that require new hardware
settings.
If this is not done, a previously learned hardware setting will continue
to be used when list mode is switched on (State = On). If no setting is
available, e.g. when the list is used for the first time, learning is
automatically activated.
Remote-control command:
SOUR:LIST:LEAR
To Next Page
Loading...
