R&S SMB Legend for Front Panel View
1407.0812.62 1.5 E-2
4 Keypad for data entry
Changing the unit
If a numeric entry is terminated with ENTER (e.g.
by clicking the rotary knob) and not with a unit key,
the unit displayed in the unit field of the parameter
in the menu is assigned. If the unit key is pressed
later, the unit is changed but not the value. The
value is recalculated to suit the new unit (e.g. the
display changes from 1000 to 1 when the Hz is
changed to kHz). The new unit is then indicated in
the value field of the menu.
Assignment
G/n dBµV giga/nano, dBµV for RF levels,
dBu for LF levels
M/µ µV mega/micro, µV for levels
k/m mV kilo/milli, mV for levels
x1 dB(m) basic unit
dBm for levels
dB for level offset and level step
width
same function as ENTER key for
unit-free values
See chapter 3, section
"Selecting a Unit -
Setting Parameters"
ON/OFF
TOGGLE
– Switches highlighted elements or a
function block on and off.
– Switches between two or more
settings, e.g. items of selection
lists. At the end of a list, the cursor
is set on the first entry again.
BACK
SPACE
– Deletes the character to the left of
the cursor.
See chapter 3, section
"Setting Parameters"
To Next Page
Loading...
