Legend for Front Panel View R&S SMB
1407.0812.62 1.4 E-2
4 Keypad for data entry
ENTER
– Calls the next menu level.
– Activates the editing mode for highlighted
numeric and alphanumeric parameters.
– Terminates a data entry; the new value is
set.In case of numeric parameters, the
unit indicated next to the value in the
menu applies.
– Switches highlighted status parameters
on and off (on/off state).
– Confirms (OK) and closes message
windows.
See chapter 3, section
"Setting Parameters"
Keys for data entry
The unit keys can either select a unit and thus
determine the absolute value, or change the unit.
Their function depends on the time at which they
are pressed during parameter entry:
Selecting the unit
If a unit key is pressed immediately after a numeric
value has been entered, it terminates the entry and
determines the multiplication factor for the
respective basic unit (e.g. the k/m key determines
the unit kHz after frequency entry).
If a level value is entered, the unit indicated on the
unit key is used (e.g. the k/m mV key determines
the unit mV for level entry). The level entry must be
active in this case, e.g. by pressing the
LEVEL key.
See chapter 3, section
"Selecting a Unit -
Setting Parameters"
To Next Page
Loading...
