Legend for Front Panel View R&S SMB
1407.0812.62 1.8 E-2
8 RF output
RF
Output for RF signal.
See data sheet
and chapter 4, section
"RF Signal"
ATTENTION
Maximum Input Levels
Do not overload the RF output. The maximum permissible back-feed is
specified in the data sheet.
9 Keys for switching RF signal and modulations
MOD ON/OFF Switches the active modulations on
and off.
RF ON/OFF
Switches the RF signal on and off.
See chapter 3, section
"Setting Parameters",
and chapter 4, section
"RF Signal" and
"Modulations"
10 Key for winbar
WINBAR Toggles between display and
blanking of the Winbar.
See chapter 3, section
"Setting Parameters"
11 Standby on/off switch
The on/off switch switches the instrument from the
standby mode to the operating state provided the
power switch on the instrument rear is switched on.
The yellow LED (right) is on in the standby mode;
the green LED (left) is on when the instrument is
ready for operation.
See chapter 1, section
"Switching On"
DANGER
Danger of shock hazard!
The instrument is still power-supplied while it is in standby mode.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX 781.665.0780 - TestEquipmentDepot.com
To Next Page
Loading...
