Rohde & Schwarz SMB 100a - Page 276

Command Description R&S SMB
1407.0806.32 6.84 E-2
STATus Subsystem
This system contains the commands for the status reporting system. *RST has no effect on the status
registers.
Queries return the current value of the respective register, which permits a check of the device status. A
decimal value between 0 and 32767 (=2
15
-1) is returned.
The configuration commands set the respective register thus determining which status changes of the
R&S Signal Generator causes the status registers to be changed. A decimal value between 0 and
32767 (=
2^15-1) is set.
Command Parameters Default
unit
Remark
STATus:OPERation:CONDition? Query only
STATus:OPERation:ENABle 0...32767
STATus:OPERation[:EVENt]? Query only
STATus:OPERation:NTRansition 0...32767
STATus:OPERation:PTRansition 0...32767
STATus:PRESet No query
STATus:QUEStionable:CONDition? Query only
STATus:QUEStionable:ENABle 0...32767
STATus:QUEStionable[:EVENt]? Query only
STATus:QUEStionable:NTRansition 0...32767
STATus:QUEStionable:PTRansition 0...32767
STATus:QUEue[:NEXT]? Query only
STATus:OPERation:EVENt?
The command queries the content of the EVENt part of the STATus:OPERation register. This part
contains information on the actions performed in the instrument since the last readout. The content
of the EVENt part is deleted after being read out.
Example:
STAT:OPER:EVEN?
'queries the STATus:OPERation:EVENt register.
*RST value Resolution Options SCPI
- - Compliant
STATus:OPERation:CONDition?
The command queries the content of the CONDition part of the STATus:OPERation register. This
part contains information on the action currently being performed in the instrument. The content is
not deleted after being read out since it indicates the current hardware status.
Example:
STAT:OPER:COND?
'queries the Status:Operation:Condition register.
*RST value Resolution Options SCPI
- - Compliant