EasyManua.ls Logo

Rohde & Schwarz SMB 100a - Page 277

Rohde & Schwarz SMB 100a
328 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
R&S SMB Command Description
1407.0806.32 6.85 E-2
STATus:OPERation:PTRansition
The command sets the bits of the PTRansition part of the STATus:OPERation register. If a bit is set,
a transition from 0 to 1 in the condition part causes an entry to be made in the EVENt part of the
register. A new event in the hardware is thus registered, e.g. the start of an adjustment.
Example:
STAT:OPER:PTR 32767
'all transitions from 0 to 1 in the condition part of the Status:Operation register
cause an entry to be made in the EVENt part.
*RST value Resolution Options SCPI
- - Compliant
STATus:OPERation:NTRansition
The command sets the bits of the NTRansition part of the STATus:OPERation register. If a bit is set,
a transition from 1 to 0 in the condition part causes an entry to be made in the EVENt part of the
register. The disappearance of an event in the hardware is thus registered, e.g. the end of an
adjustment.
Example:
STAT:OPER:NTR 0
'a transition from 1 to 0 in the condition part of the Status:Operation register
does not cause an entry to be made in the EVENt part.
*RST value Resolution Options SCPI
- - Compliant
STATus:OPERation:ENABle
The command sets the bits of the ENABle part of the STATus:OPERation register. This setting
determines which events of the Status-Event part are forwarded to the sum bit in the status byte.
These events can be used for a service request.
Example:
STAT:OPER:ENAB 32767
'all events are forwarded to the sum bit of the status byte.
*RST value Resolution Options SCPI
- - Compliant
STATus:PRESet
The command resets the status registers. All PTRansition parts are set to FFFFh (32767), i.e. all
transitions from 0 to 1 are detected. All NTRansition parts are set to 0, i.e. a transition from 1 to 0 in
a CONDition bit is not detected. The ENABle parts of STATus:OPERation and
STATus:QUEStionable are set to 0, i.e. all events in these registers are not passed on.
The command triggers an event and therefore has no query form and no *RST value.
Example:
STAT:PRES
'resets the status registers.
*RST value Resolution Options SCPI
- - Compliant

Table of Contents

Related product manuals