R&S SMB Example of Setup
1407.0812.62 2.9 E-2
Press the rotary knob to open the menu where the
RF frequency sweep menu can be selected.
Highlight RF Freq Sweep... by turning the rotary
knob.
Press the rotary knob to open the RF Freq Sweep
menu.
All sweep parameters are default except for the
sweep mode. The default settings are not
changed.
Select the Mode parameter by turning the rotary
knob. Press the rotary knob and select setting
Single from the list by turning the rotary knob.
Press the rotary knob, now the sweep mode is set
to single sweep from start to stop frequency.
To Next Page
Loading...
