Fully Utilizing Preset Function
4
Part of
Practice
104
Press to select a name to be called.
Press
to enable the setting.
The settings are changed and the screen shown in the gure appears.
Description
This loads a saved preset. You can select any one of eight types of presets. (When no names have been as-
signed, you select from among NAME1 through NAME8.) If you load a preset while
is illuminated,
goes dark. If this happens, raise the loading lever, make sure the media is loaded straight, then lower
the loading lever again to make output possible. .
Automatic loading of a saved preset when media is loaded
Procedure
Press .
Press to display the left gure.
Press
, and then .
Press .
Press to select “ENABLE.”
Press
to enable the setting.
Press in this order to go back to the original screen.
Description
Once "ENABLE" is selected, the screen for loading a preset is always displayed when the media is loaded.
Follow the procedure given below to use the loaded preset.
How to use the loaded preset
When you press at the end of the media loading process, the screen shown in the gure appears.
When you press
, the preset displayed in the screen is loaded. (Pressing before pressing
performs setup with current settings without loading the preset.)
The preset displayed in the screen is either the last loaded preset or last saved preset.
You can select other presets by pressing
and .
To Next Page
Loading...
