Accommodating to the Types and Condition of Media
4
Part of
Practice
115
Using Transparent Media
Procedure
Press .
Press several times to display the screen shown
on the left.
Press
twice.
Press to select “DISABLE.”
Press
to enable the setting.
The settings are changed and the screen shown in the gure appears.
Description
This setting enables or disables detection of the leading and trailing edges of the media. It is normally set to
"ENABLE." When transparent media is loaded, set it to "DISABLE."
When "DISABLE" is selected, "ROLL," "TU," and "TU2" are available in setting the media. At this time, set the
margin from the leading edge of the media to the print start position to 75 mm or more.
When [EDGE DETECTION] is set to "DISABLE," printing operation does not stop when the media runs out. If
media runs out while printing is in progress, immediately press
to quit printing. Otherwise, there is a
chance that the platen or the like may become soiled by ink or that ink may get inside and damage the machine.
Default Setting
[EDGE DETECTION]: ENABLE
Printing Hard-to-dry Media
Procedure
Press .
Press several times to display the screen shown
on the left.
Press
, and then .
Press .
Press to select a value.
Larger values produce progressively slower movement of the media,
enabling you to extend the drying time accordingly.
Press to enable the setting.
Press in this order to go back to the original screen.
To Next Page
Loading...
