Roland XR-640 - Correcting Misalignment for Printing and Cutting Position When Using Crop Marks

4
Performing Printing and Cutting Separately
Part of Practice
134

Hold down for one second or longer.

When the screen shown in the gure appears, press
.
The number of the align point you set is automatically determined.
Align point is set.

Repeat Procedure

~

to specify other align points as required.

Send the cutting data and perform cutting.
Correcting Misalignment for Printing and Cutting Position When Using Crop Marks
Note: When performing this setting, make sure to set the correction value of [CUTTING MENU CALIBRATION]
to “0.00%.”
 P. 124, "Performing Distance Correction During Cutting"
Procedure

Make sure the [AUTO ENV. MATCH] menu item is set to "ENABLE."
 P. 128, "Viewing the Automatic Environment Correction Function Settings"

Perform bidirectional adjustment.
 P. 111, "Correcting for Misalignment in Bidirectional Printing"
 P. 112, "Correcting for Misalignment in Bidirectional Printing More Precisely"

Hold down and press .

Press to display the left gure.
Press
.
SETTING
ALIGN POINT 1
About Align Points
The numbers for align points are determined with reference to the location of the base point. You
cannot set an align point unless you specify a base point. Redoing the setting for the base point clears
any align points that have been set.
CUTTING MENU
CROP-CUT ADJ.
This indicates that the base point
and align point 1 have been set.