4
Part of
Practice
Performing Printing and Cutting Separately
133
Aligning Manually and Cutting
Depending on the type of media, it may not be possible to detect crop marks automatically. When crop marks
cannot be detected automatically, you perform alignment manually.
1.
Set the base point.
Use to align the center of the blade with the location
shown in the gure.
Press .
The character “B” appears on the lower left of the setting screen. The
base point is set.
2.
Set the align points.
Use to align the center of the blade with the location
shown in the gure.
To Next Page
Loading...
