Roland XR-640 - Setup of Media; About [Media Setting] Menu; Setup of Media ([Media Setting] Menu)

2
Basic Operation
51
Setup of Media
About [Media Setting] menu
To ensure the optimal output according to the media size and type, various setting items are provided in this
machine. However, it is hard work to perform these settings one by one referring to this document. So, this
machine provides the [Media Setting] menu that guides these settings in the interactive mode. Using this
menu, you can set all of the basic settings only by setting according to the instructions on the display.
Since the setting details can be stored as the preset menu, you can promote your operation eciently saving
the setup steps when using the same type of media. Once storing the basic settings as the preset, you can do
ne adjustment according to need.
The items set through the [Media Setting] menu can be also set individually.
Setup of Media ([Media Setting] menu)
Note: If any setting is not needed for each setting item, you can go to the next menu by selecting [NEXT].
1. Starting the [Media Setting] menu.

Load media.
Check that no sagging is found on the media. If any sagging exists, the followed correction value settings
do not work eectively.
 P. 39, "Loading Media"

Press .

When the left gure is displayed, press .
2. Set the temperature of preheater, print heater and dryer.

Use to set the temperature.
Recommended temperature: 40 °C
Press to enable the setting.

Use to set the temperature.
Recommended temperature: 40 °C
Press to enable the setting.
 Only Printing: Perform the procedure 1. to 6. ,and 10. to 11.
 Printing & Cutting: Perform all the procedure 1. to 11.
MENU
MEDIA SETTING
PRE 40
40 40
PRINT 40
40 40
Temperature
to be set
Current preset
temperature