Accommodating to the Types and Condition of Media
4
Part of
Practice
119
Using Sticky Media
Procedure
Press .
Press several times to display the screen shown
on the left.
Press
.
Press several times to display the screen shown
on the left.
Press
.
Press to select "ENABLE."
Press
to enable the setting.
Press in this order to go back to the original screen.
Description
Some types of media may tend to stick to the platen. Starting printing with the media sticking to the platen
may make normal media feed impossible and cause the media to jam. When you're using such media, set the
[MEDIA RELEASE] menu item to "ENABLE." This peels o the media if sticking before starting printing. Note,
however, that media feed may be unstable when printing is performed after executing this operation. Leave
this menu item set to "DISABLE" unless you specically need to change it.
Default Setting
[MEDIA RELEASE]: DISABLE
To Next Page
Loading...
