4
Fully Utilizing Cutting Function
Part of
Practice
124
Performing Distance Correction During Cutting
*When you’re performing printing followed by cutting, be sure to set the correction value to “0.00%.” Otherwise
the printing and cutting positions may become misaligned
Procedure
Hold down and press .
Press twice to display the screen shown on the
left.
Press
.
Press .
Press
to select a correction value.
Set the correction value of media feed direction.
Press to enable the setting.
Press
, and then .
Press .
Press
to select a correction value.
Set the correction value of head movement direction.
Press to enable the setting.
Press in this order to go back to the original screen.
Description
The movement distance of the media changes subtly depending on the media's thickness. This means that
the length of a line when cut may dier from the length setting in the data. You enter a correction value when
you want to align the lengths.
Default Setting
[FEED SETTING]: 0.00%
[SCAN SETTING]: 0.00%
To Next Page
Loading...
