Fully Utilize the Media Heating System
4
Part of
Practice
109
Description
"ENABLE" : media feed is performed until the trailing edge of the printing area is positioned on the dryer.
A margin from the print end position to the subsequent print start position is xed at 200 mm. The margin
set on the computer is ignored.
P. 110, "Using an Optional Dryer"
"DISABLE" : media feed stops simultaneously when printing ends. This means that the trailing edge of the
printing area is not fed to the dryer unless you continue with a subsequent printing operation.
Default Setting
[FEED FOR DRY]: DISABLE
Setting the Drying Time after Printing
Procedure
Hold down and press .
Press to display the screen shown on the left.
Press
.
Press to select the interval.
Press
to enable the setting.
Press in this order to go back to the original screen.
Description
Set the interval after the 1st page is printed. The next operation is not started until the set time passes.
is lighting during the interval. When pressing while is lighting, the interval is nished and
the next operation is started. When holding on
while is lighting, output is canceled.
You can also make this setting on the software RIP. When you have made the setting on the software RIP, the
software RIP's setting is used.
Default Setting
[DRYING TIME]: 0 min
To Next Page
Loading...
