Roland XR-640 - Accurately Adjusting the Cutting-In Amount

4
Part of Practice
Fully Utilizing Cutting Function
123
Accurately Adjusting the Cutting-in Amount
When you want to perform accurate and ne adjustment of the cutting-in amount, such as when cutting media
with thin backing paper, you can obtain good results by adjusting the tip of the blade. Turn the cap portion of
the blade holder to adjust the amount of blade extension. Each indicator tick corresponds to 0.1 millimeters,
and adjustment for 0.5 millimeters can be made by rotating the cap one full turn.
Note that making the amount of blade extension too small may cause the tip of the blade holder cap to touch,
and may soil and damage the printed surface. It's important to be especially careful about this when you're
using media that has poor ink adhesion properties.
Rough Estimate for the Amount of Blade Extension
Use the following dimension as a rough estimate for setting the amount of blade extension.
Amount
of blade
extension
=
2
Thickness of
the material
portion
+
Thickness of the
backing paper
Min. 0 mm
Amount of blade extension
Max. 2.5 mm
Blade
Blade holder
Half of the
backing paper
Amount of blade
extension is approxi-
mately equal to the
cutting-in amount.
Material portion
Backing paper portion