Roland XR-640 - Page 124

4
Fully Utilizing Cutting Function
Part of Practice
122

Press in this order to go back to the original screen.
Evaluating the Results of a Cutting Test
Check the shape of the test pattern.
The cut shape is distorted.  Decrease the value of [Speed].
Peel off the circle.
The rectangle also peels o.  Increase the value of [Force].
Some uncut areas remain.  Decrease the value of [Speed].
Peel off the rectangle.
The blade should leave faint traces on the backing paper.  Do not change the value of [Force].
The blade trace is indistinct.  Increase the value of [Force].
The blade trace is too deep and cuts into the backing paper.  Decrease the value of [Force].
Check the shape of the rectangle.
A Do not change the value of [OFFSET].
B (The corners are rounded.)  Increase the value of [OFFSET].
C (The corners have "horns.")  Decrease the value of [OFFSET].
Circle
Rectangle