Roland XR-640 - Correcting Misalignment of the Printing and Cutting Positions

4
Part of Practice
Fully Utilizing Cutting Function
125
Correcting Misalignment of the Printing and Cutting Positions
Note: When performing this setting, make sure to set the correction value of [CUTTING MENU CALIBRATION]
to “0.00%.”
 P. 124, "Performing Distance Correction During Cutting"
Procedure

Make sure the [AUTO ENV. MATCH] menu item is set to "ENABLE."
 P. 128, "Viewing the Automatic Environment Correction Function Settings"

Perform bidirectional adjustment.
 P. 111, "Correcting for Misalignment in Bidirectional Printing"
 P. 112, "Correcting for Misalignment in Bidirectional Printing More Precisely"

Hold down and press .

Press .

Press .
The test pattern (P&C1) is printed and cut. The test pattern is printed
at three locations on the media: at the two edges and in the center.
When adjustment is needed, go on to the next Procedure.

Press to display the left gure.
Press
.
The test pattern (P&C2) is printed and cut.
For information on the method of test pattern check, refer to the next page.
CUTTING MENU
PRINT-CUT ADJ.
PRINT-CUT ADJ.
TEST PRINT
To check the test pattern (P&C1)
Check to make sure that the printing position and the cutting position are aligned.
PRINT-CUT ADJ.
TEST PRINT 2
Printing position and Cutting position
are misaligned.
Printing position and Cutting posi-
tion are aligned.
Cutting position
Printing position