Roland XR-640 - Page 128

4
Fully Utilizing Cutting Function
Part of Practice
126

Press to display the left gure.
Press
.

Press to select a correction value of [F]
(feed direction of media).
Press
to select a correction value of [S]
(movement direction of head).
Press
to enable the setting.

Press in this order to display the left
gure.
Press
.
The test pattern (P&C1) is printed and cut. If the printing and cutting
lines are aligned, adjustment is complete. If further adjustment is
needed, go back to Procedure

and ne-tune the adjustment.
To check the test pattern (P&C2)
The point where the cutting line intersects the correction-value scale is the correction value. Check
the scan direction and feed direction respectively.
PRINT-CUT ADJ.
SETTING
F : -0.30 -0.30mm
S : 0.00 -0.20mm
PRINT-CUT ADJ.
TEST PRINT
Feed direction
Cutting line
Scan direction
Cutting line
For the gure, the correction
value is “-0.3.”
Correctionvalue scale
Cutting position
Printing position and Cutting position
are aligned.
Printing position