Roland XR-640 - Getting Ready to Receive Data from a Computer

2
Basic Operation
Outputting
67
Getting Ready to Receive Data from a Computer
When P. 39, "Loading Media" and P. 51, "Setup of Media" are completed, get ready to receive the data
from a computer.
CAUTION
Never touch the print heads while output is in progress.
The print heads move at high speed. Hitting may cause injury.
Procedure

Close the front cover.

Make sure stays steadily lit.
If
is not lit, pull the loading lever and press .

Wait until stays steadily lit.

Make sure the top menu is displayed.
If the top menu is not displayed, press
, then press .
Output Is Not Possible in These Situations
 The machine does not run when the front cover is open.
 Never open it when printing is in progress.Doing so interrupts printing.
 Data from the computer is not accepted when
is dark.
 Printing does not start until
lights up. (If all of the pre-heater, print-heater, and dryer are
set to "OFF," printing is possible even if
is not lit.)
 Data from the computer is not accepted when you are not at the top menu.
Top menu
Flashing 
Steadily lighted
Steadily lighted