Fully Utilize the Media Heating System
4
Part of
Practice
108
Control of Media Heating System during Preheating
Note: Preheating: State that the main power and the sub power are switched on and is not lighted
(state that media setup is not completed)
Procedure
Hold down and press .
Press to display the screen shown on the left.
Press
.
Press to select setting.
MENU: The system performs heating to the preset tem-
perature at all times, without lowering the temperature
during preheating.
30°C: The system keeps 30°C during preheating.
OFF: The system switches the media heating system off
during preheating.
Press
to enable the setting.
Press in this order to go back to the original screen.
Default Setting
[PREHEATING]: 30°C
Drying the Trailing Edge of the Printing Area on the Dryer
Procedure
Hold down and press .
Press .
Press to select “ENABLE.”
Press
to enable the setting.
Press in this order to go back to the original screen.
To Next Page
Loading...
