Printer Does Not Start Up!
6
FAQ
162
The Media Heating System Doesn't Warm Up
Is media loaded?
The media heating system does not warm up to the preset temperature when
is dark (by default).
Load media and wait for the machine to warm up.
P. 105, "Fully Utilize the Media Heating System"
Is the temperature of the room too low?
Use the machine in an environment where the temperature is 20 to 32°C (68 to 90°F).
Cannot cut off the media
Is the separating knife mounted?
If the separating knife is not mounted, you cannot cut o the media.
P. 97, "Replacing the Separating Knife"
Cannot select "EDGE" and "PIECE".
Is "EDGE DETECTION" set to "DISABLE"?
If "EDGE DETECTION" is set to "DISABLE", the front edge and trailing edge of the media cannot be detected,
and consequently "EDGE" and "PIECE" cannot be selected in "SETUP SHEET". To select "EDGE" or "PIECE", set
"ENABLE" to "EDGE DETECTION".
P. 115, "Using Transparent Media"
To Next Page
Loading...
