4
Performing Printing and Cutting Separately
Part of
Practice
132
If Automatic Alignment Cannot Be Performed
If the machine fails to detect the crop marks, the screen shown
in the gure appears and operation stops.
Press any key to go back to the original screen.
Reload the media, and then send the data again.
*When you want to perform automatic alignment with lengthy media, we recommend performing
output with the data separated into sizes that are as short as possible.
The crop marks cannot be detected easily because of the eects of media warping or the like. With
large sizes, error due to warping and the like increases, making smooth detection impossible. In such
the cases, perform alignment manually.
P. 133, "Aligning Manually and Cutting"
To Quit Detection and Start Cutting
Procedure
Press during detection of crop marks.
Crop-mark detection stops. Depending on the content of the data, some time may pass
before detection actually stops.
Press .
This stops detection and starts cutting.
*Note: After pressing
in Procedure
, resuming detection or canceling output is also
possible.
P. 69, "Pausing and Canceling Output"
To Next Page
Loading...
