4
Part of
Practice
Performing Printing and Cutting Separately
135
Press .
The test pattern (C&C1) is printed and cut.
When adjustment is needed, go on to the next Procedure.
Press to display the left gure.
Press
.
The test pattern (C&C2) is printed and cut.
Press to display the left gure.
Press
.
To check the test pattern (C&C1)
Check to make sure that the printing position and the cutting position are aligned.
CROP-CUT ADJ.
TEST PRINT 2
To check the test pattern (C&C2)
The point where the cutting line intersects the correction-value scale is the correction value. Check
the scan direction and feed direction respectively.
Printing position and Cutting position
are misaligned.
Printing position and Cutting position
are aligned.
Cutting position
Printing position
Feed direction
Cutting line
Scan direction
Cutting line
For the gure, the correction
value is “-0.3.”
Correctionvalue scale
To Next Page
Loading...
