Roland XR-640 - Page 138

4
Performing Printing and Cutting Separately
Part of Practice
136

Press to select a correction value of [F]
(feed direction of media).
Press
to select a correction value of [S]
(movement direction of head).
Press
to enable the setting.

Press in this order to display the left
gure.
Press
.
The test pattern (C&C1) is printed and cut. If the printing and cutting
lines are aligned, adjustment is complete. If further adjustment is
needed, go back to Procedure

and ne-tune the adjustment.
Description
Depending on the composition of the media, the positioning of printing and cutting may be misaligned even
when you're using crop marks. Make corrections for misaligned printing and cutting for the media you're using.
Default Setting
[F] (feed direction): 0.00 mm
[S] (scanning direction): 0.00 mm
F : -0.30 -0.30mm
S : 0.00 -0.20mm
CROP-CUT ADJ.
TEST PRINT
Cutting position
Printing position and Cutting
position are aligned.
Printing position