Roland XR-640 - Page 156

Changing ink type

Conrm that the drain bottle is loaded, and then press .

By following the on-screen instructions, remove and insert the SOL INK cartridges and
dummy cartridges.

When draining of the ink is complete, the message shown in the gure
appears.
Dismount the drain bottle and discard the drained ink.
After discarding the drained ink, mount the drain bottle again.

Press .
The sub power is switched o.
2. The sub power is switched off.

Press the sub power button.

Press or .

Press to select ink type.
Select the ink type according to which color is used, white or metallic silver.
White
(W)
Metallic silver
(MT)
Ink Mode

E-SOL MAX2 LkW

E-SOL MAX2 LkMT

After selecting the Ink Type, press .

Conrm the Ink Type is correct, and then use
to select [Yes].
Press
.

Make sure the drain bottle is installed.
Press
.
CHECK
DRAIN BOTTLE
EMPTY
DRAIN BOTTLE
Go on to the next procedure as soon as the sub power is switched o. If you leave the machine with
ink drained, it damages the print heads.
SELECT INK TYPE
E-SOL MAX2 7C
SELECT INK TYPE
E-SOL MAX2LkW
E-SOL MAX2 LkW
[
YES
] No
INSTALL
DRAIN BOTTLE
5
To Administrators
154