Changing ink type
5.
Clean the print heads.
Insert the provided hexagon wrench into the hole shown in
the gure below. Rotate it in the direction of arrow until the
buzzer sounds once and hold it with your hand.
The valve will close.
While holding the hexagon wrench with your hand, wait until the next
instruction is displayed.
When the screen shown to the left appears and the buzzer
sounds twice, rotate the hexagon wrench in the direction of the
arrow shown in the gure below until the buzzer sounds once.
The valve opens.
Open the valve immediately although cleaning continues inside the ma-
chine even after the screen shown on the left appears. Leaving the valve
closed may cause damage to the print heads.
Wait until the displayed next operation appears.
This operation takes about 5 minutes. During this operation, do not walk away from the machine
and complete this operation by following the on-screen instructions. Walking away before the
operation is complete may cause damage to the print heads, making the machine unusable.
CLOSE THE VALVE
NOW PROCESSING..
To Next Page
Loading...
