An Error Message Appears
6
FAQ
177
[SETUP SHEET AGAIN]
The media setup is canceled because two or more of the following conditions are present.
"EDGE" or "PIECE" is selected in [SETUP SEET], where media setup is done.
"AUTO DISPLAY is set to "ENABLE" (the screen for loading a preset is displayed at the time
of media setup).
P. 104, "Automatic loading of a saved preset when media is loaded"
In the loaded preset, "EDGE DETECTION" is set to "DISABLE" (detection of the leading and
trailing edges of the media is disabled).
P. 115, "Using Transparent Media"
When "EDGE DETECTION" is set to "DISABLE," you cannot select "EDGE" or "PIECE" in [SETUP SHEET]. For this
reason, the setting is canceled if two or more of the above conditions are present. If you want to select "EDGE"
or "PIECE," call a preset for which "ENABLE" has been selected for [EDGE DETECTION], or set [EDGE DETECTION]
to "ENABLE" before [SETUP SHEET].
[DATA ERROR CANCELING...]
Output was stopped because a problem was found in the data received.
Operation cannot be continued. Check for a problem with the connector cable or the computer, and redo the
operation from the step of loading the media.
[PINCHROLL ERROR INVALID LEFT(RIGHT) POS]
The left (right) pinch roller is positioned at a location where it does not pinch the media.
First, move the loading lever to the rear and move the left (right) pinch roller to the correct location.
P. 39, "Loading Media"
[PINCHROLL ERROR LOWER PINCHROLL]
was pressed without rst lowering the pinch rollers.
Press any key to clear the error. Pull back the loading lever, then press .
The pinch rollers were raised while was illuminated.
The error is cleared automatically after a short wait. Never move the loading lever while printing is in progress.
[WRONG CARTRIDGE]
A cartridge that cannot be used was installed.
Remove the cartridge to clear the error. Use a cartridge of the specied type.
To Next Page
Loading...
