Roland XR-640 - Page 187

Specications
7
Main Specications
185
Dimensions (with stand)
2,948 (W) x 1,211 (D) x 1,260 (H) mm (116.1 (W) x 47.7 (D) x 49.6 (H) in.)
Weight (with stand)
205 kg (452 lb.)
Environ-
mental
Power on (*8)
Temperature: 15 to 32°C (59 to 90°F) (20°C [68°F] or more recommended),
humidity: 35 to 80%RH (non-condensing)
Power off
Temperature: 5 to 40°C (41 to 104°F), humidity: 20 to 80%RH (non-
condensing)
Accessories
Exclusive stands, power cord, blade, blade holder, media clamps, media
holder, replacement blade for separating knife, software RIP, User's Manual,
etc.
*1
The length of printing or cutting is subject to the limitations of the program.
*2
 Media type: Media specied by Roland DG Corp.
 Temperature: 25°C (77°F), humidity: 50%
 Roll media must be loaded correctly.
 Applicable when all pinch rollers available to the media width are used.
 Side margins: 25 mm or more for both the left and right margins
 Front margin: 35 mm or more
 Excluding expansion/contraction of the media
 Not assured when the print heater or dryer is used.
 All correction or adjustment function of this machine has been made properly.
*3
 Print travel: 1 m
*4
 [PREFEED] menu item must be set to "ENABLE."
Range for assured repetition accuracy
 For media with a width exceeding 610 mm: Length 4,000 mm
 For media with a width of 610 mm or less: Length 8,000 mm
*5
 Provided that media length is under 3,000 mm
 Excludes the eects of slanted movement and of expansion and contraction of the media.
*6
 Data size:1,000 mm in the media-feed direction, 1,600 mm in the carriage-movement direction.
 No lamination
 Automatic detection of crop marks at 4 points when media is reloaded.
 During cutting, [PREFEED] menu item must be set to "ENABLE."
 Excluding possible shift caused by expansion/contraction of the media and/or by reloading the media.
*7
 Warm-up is required after power up. This may require 5 to 20 minutes, depending on the operating environment.
 Depending on the ambient temperature and media width, the preset temperature may fail to be reached.
*8
 Operating environment
Use in an operating environment
with this range.