3
Maintenance
Replacing Consumable Parts
96
Replace the blade.
Support the screw from below and insert
the blade holder
If installed without supporting the screw in this way,
cutting quality may become poor.
Tighten the screw.
Tug the blade holder upward to make sure it does
not come loose.
3.
Quit the blade replacement menu.
Close the front cover.
Press
.
Press in this order to go back to the original screen.
4.
Adjusting the Cutting Conditions and Cutting-in Amount.
P. 121, "Fine-tuning the Cutting Conditions"
P. 123, "Accurately Adjusting the Cutting-in Amount""
Old blade
New blade
Pin
Press this pin.
Remove the old blade.
Install a new blade.
Screw
Insert until the collar is
ush with the surface.
To Next Page
Loading...
