EasyManuals Logo

Rotax 914 F Installation Manual

Rotax 914 F
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
Reference
Modification-No.
- 0 -
Page
51
Date
1996 05 10
Install
914 F
NOTE: There is no need for a checkvalve for the operation of the two
electric fuel pumps since the pump itself won't allow any
passage against correct direction of flow
ATTENTION: Employ GENUINE-BOMBARDIER-ROTAX fuel pumps only.
Non-compliance will release BOMBARDIER-ROTAX from
any liability.
Place of installation:
Installation of the fuel pumps principally near the fuel tank to gain
advantage of a cool location, especially important at tendency of vapour
locks.
Install the pump in low position, if possible below fuel tank, free of
vibrations. Therefore, fuel pump attached directly on the engine is not
permitted.
Max. suction head 250 mm (10 in).
WARNING: Certification to the latest requirements such as FAR or JAR
has to be conducted by the aircraft builder.
WARNING: Installation of the fuel pumps in the engine compart-
ment is not permitted since the fuel pumps are not of a
fire resistant construction and because of the risk of
vapour lock formation.
WARNING: Should the situation arise, certification to the latest require-
ments such as FAR or JAR would have to be conducted by
the aircraft builder.

Table of Contents

Other manuals for Rotax 914 F

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rotax 914 F and is the answer not in the manual?

Rotax 914 F Specifications

General IconGeneral
BrandRotax
Model914 F
CategoryEngine
LanguageEnglish

Related product manuals