1. Operating Procedure
2-2
To start processing operation, a user must have "logged on" to the instrument. Only one user can "log on" to the
instrument at a given time.
1. Touch LOG ON located in the bottom left-hand corner of the screen. The Password screen will appear. If other
user is currently logged on, the LOG OFF button is shown in the bottom left-hand corner of the screen, with the
name of the logged-on user and an applicable icon shown at the top of the screen. Other user cannot log on to
the instrument until the current user logs off.
2. Use the ten-key keypad to enter a password in the password entry field. Refer to p.1-20 for information on how
to enter from the ten-key keypad.
The default passwords are shown below. Refer to p. 1-21 for the differences between manager passwords and
user passwords.
100000, 200000, 300000, 400000
1, 2, 3, 4, 5, 6, 7, 8, 9, 10
11, 12, 13, 14, 15, 16, 17, 18, 19, 20
To cancel the log on process, touch Cancel. The password entry screen will close and the previous screen will
appear again.
3. Enter the password and touch Enter. When the correct password is entered, the name of the logged-on user
appears at the top of the screen. A wrong password is not accepted.
[1] Logging off the instrument
Touch LOG OFF located in the bottom left-hand corner of the screen. The name of the user who was logged on
before will disappear, along with the icon, from the top right-hand corner of the screen. This shows the user has
logged off.
To Next Page
Loading...
Need help?
General
