LED R&D Lab(VD)
105
• Vertical extension (in case of 8X8 extension)
1. Attach EXTENDED SHEET to FRAME BEZEL TOP
① TOP Attached to the inner upper part guide (red dotted line)
② After attaching from the end to the end of the TOP, cut the remaining part for use.
＊EXTENDED SHEET 사양 (W3.5, L806, T2.0)
＊ If there is no GAP, connect without attaching the SHEET
2. Attach GAP SHEET(T2.5) to FRAME BEZEL TOP
① Attached according to the inner hole of the TOP
② Attached by Center-Center
＊GAP SHEET Specification (RUBBER, W9, L17.9, T2.5 + double-sided tape)
◇ Bezel Extension Installation
7. Frame Bezel installation
To Next Page
Loading...
