LED R&D Lab(VD)
132
① Service Port is a terminal dedicated to monitoring to check the operation status of the source being played and using the OSD
during the initial installation of the S-Box.
② The resolution of the corresponding PORT is FHD (1920*1080 @ 60Hz).
③ Screen flickering and cracking may occur when UHD resolution source is input to S-BOX, but this is a phenomenon in which the
corresponding port output is fixed down scalin without a specific scaling algorithm, and is not related to the actual LED cabinet
screen output.
④ Connect a monitor to use SERIVCE PORT.
⑤ Network information is set in Menu → Network → Open Network Settings.
⑥ Check the network ping with a laptop, etc.
⑦ Select RJ-45 from Home → ID Settings → PC Connection Cable menu.
[Caution!] This port is for service only, and there is no function for users. Please do not connect.
④ S-box Grouping Support Frequency (2/2)
SNOW-AAE
8. S-Box Installation and Connection
To Next Page
Loading...
