LED R&D Lab(VD)
80
Temporary Solution for using adsorber
1. Attach OPP TAPE to the module to which the adsorber is to be attached.
2. Place the adsorber on the OPP TAPE in UNLOCK state.
3. Press the adsorber and adsorb it. (LOCK status)
※ ① When attaching TAPE, attach it to prevent bubbles as much as possible.
※ ② Fold the end before attachment to make it easy to remove TAPE after completion of work
※ ③ Do not exceed 30 minutes of OPP TAPE attachment time.
※ ④ If the module has a tape adhesive layer left after removing the OPP TAPE, be careful not to enter between the modules when removing it.
100~130mm
OPP TAPE
① ②
Adsorption state (LOCK)
PUSH
Un-Lock
Lock
To Next Page
Loading...
