LED R&D Lab(VD)
40
◆ Preparations before installation
⒧ Using the 1.5mm wrench in the Frame Kit component (Item 15 in
Page 49), push the back of the Docking Hook Pin and protrude it so
that it can be taken out from the front.
⑨ Removal of Lower Docking Dust Cap
⑧ Removal of Upper Docking Dust Cap
⑵ Remove the hook pin protruding from the front by pulling it out
completely, then lift the dust cap upwards to remove it.
⒧ Since the lower part of the docking dust cap is made of
rubber, it can be removed by pulling it downward without special
equipment.
* As there is a risk of electric shock, be sure
to perform the work below with AC power
removed.
REAR FRONT
2. Preparation for Cabinet Installation
To Next Page
Loading...
