LED R&D Lab(VD)
59
4. Frame installation
※ Reference2. (Optional) Frame extension in horizontal direction
* Width adjustment is possible only for the part where two FRAME H are connected and installed.
* Apply when it is difficult to adjust Z-SEAM due to reduced module movement during extended installation.
- Disassemble the screws FH, M4, L6 in the adjustment area. (Fig.1)
- Separate the BRACKET-SUPPORT by disassembling the screws (BH,M4,L6) in the ASSY FRAME VERTICAL,
which is the boundary of the 4th stage. (Fig.2)
SCREW (BH,M4,L6)
REMOVE
Fig.2 DISASSEMBLE THE BRACKET-SUPPORTFig.1 FRAME H SCREW REMOVE
To Next Page
Loading...
