LED R&D Lab(VD)
57
4. Frame installation
④ Install the assembled frame on the wall (Fig.1)
※ Before installation, it is necessary to move it upright to prevent bending during handling. (Lay down and don’t move)
- Fasten 1 place (A) in the upper center of the center, align the horizontal and vertical with a horizontal system, and then fasten the
remaining 15 places.
- If necessary, use SPACER-ETC to adjust the flatness between the wall and the frame horizontal.
- If necessary, adjust the flatness between the wall and frame vertical by adjusting the HOLDER-LEVER.
Fig.1 Fastening the assembled frame to the wall
Adjustment of flatness between
walls using Spacer-ETC
A
Using a level
Fig.2 Select and tighten the SCREW suitable for the installation environment
Fig.3 FRAME VERTICAL flatness adjustment with HOLDER-LEVEL adjustment
MAX. +2mm
In case of insufficient gap, holder is attached
Screw tightening after adjustment
FRAME KIT
FRAME KIT
To Next Page
Loading...
