Samsung IWA Series - 10. Settings; How to Use

LED R&D Lab(VD)
178
10. Settings / How to Use
1. Choose Model type according to your S-Box type. IP
address of each Cabinet Groups should be set if that is
using. Click Connect after setting Number of Cabinets.
2. (8K or 4K-Pillar type) Choose I/G order according to screen
set. Z-Order or Reversed N-Order are possible.
※ Same with S-box
※ Set the last IP address of Cabinet Group
as different with S-Box. And all each Cabinet
Group’s IP addresses should be different.
[★ Caution!]
When configuring LED cabinet network settings, it is recommended that a static IP address be used.
If DHCP is used and the IP address is changed, the connection with LSM may be disconnected.
The 192.168.10.x band is used for internal communication with LED cabinets.
Use an IP address that does not belong to this band.
Use the IP address for LED (x4) assigned by your IT administrator. Do not assign an IP address
arbitrarily.
10-1. Control Program for PC
 If IP addresses are already set for the cabinets, select the
“Connect
with existing settings” checkbox.
 You only need to give IP address to Cabinet Group that actually
needs to be used.
 In case of “With Cabinet IP (8K)”, the second IP address area of
each Cabinet Group are not used.
 In case of “With Cabinet IP (4K-Pillar)”, Group 5 ~ Group 8 are
not used.