LED R&D Lab(VD)
39
2. Preparation for Cabinet Installation
◆ Preparations before installation
⑥ After removing the cover corner, remove the 4 screws as shown in the figure. (Fig.6)
※ Caution : Please, Don’t forget front service can be IMPOSSIBLE, if the screw is not removed.
⑦ Assemble 2 screws provided as accessories at the top of the cabinet.
(Fig.7)
⑧ The Cover-Power of Cabinets the power cable connected in should be gone down like the picture below.
- Let Cover-Power go down to connect the power cable
※ Caution : Lowering Cover-Power will disconnect AC power connection from lower cabinet.
Please maintain Cover-Power in closed position except to connect primary AC power cable.
Fig.6 Remove screw Fig.8 Move Cover Power
※ SCREW 2pcs
SIDE VIEW
Fasten it until it comes out a
little more than the GUIDE line.
Fig.7 Assemble screw
※ SCREW 4pcs
※ Push the screw so that the
thread is mounted on the
tap and release it.
To Next Page
Loading...
