LED R&D Lab(VD)
90
S-BOX
BRACKET-SUPPORT
Bridge-Box
I/G
◇ Bezel installation
1. Before installing the Frame Bezel Top/Bottom,
Remove the Cover Cap and attach the sensor according to the sensor position.
* The sensor is included in the S-BOX component accessory as shown in the picture.
* Based on 4x4, 1 Sensor Bottom and 1 Bluetooth/Wi-Fi will be added.
* Sensor only applies to IWA model.
(※ Supported after IFA S-box changes, July 21~)
ACCESSORY(Sensor, Cable, etc..)
SENSOR BOTTOM
(IR/ Iight sensor)
Bluetooth/Wi-Fi
7. Frame Bezel installation
To Next Page
Loading...
