LED R&D Lab(VD)
84
2 3 4
8 9 10
5
11
6
12
◇ Screen inspection when installing CABINET (Service JIG / IWA, IFA common)
※ Insert the service jig into the docking signal connector on the top of the cabinet as shown below.
※ Run Test Patten by pressing Tact Switch of service Jig
※ Screen abnormality and seam inspection by executing low gradation White / Red / Green / Blue Patten in the
vertically connected cabinet
[Screen inspection using upper docking and service jig when installing cabinet]
2 3
4
Click
Click
Click
13
7
1
1
8
2
1
※ Run Test Patten to review the stability of the upper and lower docking connections and Seam
※ Patten Color changes every time you click Test Patten.
※ Service Jig detail shape
5. Cabinet + Frame installation
To Next Page
Loading...
