Samsung IWA Series - IG Settings by screen configuration

LED R&D Lab(VD)
116
No.
Screen
type
IG settings
Dip SW
Settings
IG
Port
Video
(Vx1)
NO. 1
NO. 2
NO. 3
Usage
ETHERNET STB_EN
REDUNDANCY
SW (
UART)
PILLA_DET
1
Cable
-less
Primary
IG
(Default)
FWD O O O O N/C
Primary IG
BWD O O O O O
2
Redundancy
IG
FWD O X X X N/C
Redundancy IG
BWD O X X X X
3 Cable
FWD/BWD
FWD O O O O N/C
FWD/BWD config
Using cables
BWD O X X X X
□ IG Settings by screen configuration ( SNOW-AAE Only )
- Manual IG Switch settings decide Vx1 / STB Power / UART specification by screen type
- Settings by screen type
※ AAE IG Specifications
DIP Switch
※ Default : Cable-less Primary IG
※ Dip Switch Specifications by Switch numbers
Switch
No
Function Specification High Low Used for
1
ETHERNET Open / Short for Ethernet signal Open Short
Cable + Cable-less
STB_POWER Open / Short for Cabinet Power Control Open Short
2 REDUNDANCY SW Open / Short for Cabinet UART signal Open Short
For Cable-less
Screen
3 PILLAR Connection Open / Short Pillar mode signal Open Short
For Cable-less
Screen
4 N/A No use X X No use
8. S-Box Installation and Connection