LED R&D Lab(VD)
109
18. Fasten to FRAME BEZEL TOP using two M3 and L5 screws each. (Fig.1)
* When a gap occurs in the middle of the bezel, attach a sheet bezel to prevent the gap from being seen from the front.
(According to the degree of separation, the number of SHEET BEZELs is added consecutively and supplemented.)
19. Using 6 M4, L8 screws, fasten the FRAME BEZEL TOP and the hole at the top of the cabinet. (Fig.2)
◇ Bezel Installation
M4,L8
[Fig.1]
[Fig.2]
M3,L5
Sheet Bezel
SHEET BEZEL
From the outside/top of the BEZEL
attached to the inside
7. Frame Bezel installation
To Next Page
Loading...
