LED R&D Lab(VD)
204
STP RJ45 shielded Plug. RJ45 Connector should be CAT6 or CAT7 shielded RJ45 and load bar.
Inserting a conductor (conductor) into the plastic loader: Insert the conductor into the load bar of the RJ45 connector as
shown below in the conductor structure (T-568B). Plastic load bar is absolutely necessary (because the thickness of the CAT6
cable is not located flat on the RJ45 connector like the general CAT5)
⑨ Finishing method for HDBase-T Cable
Load bar
Wires aligned with Load bar
Load bar and Drain wire
• S-Box Connection
Appendix 2 - S-Box Installation and Connection
To Next Page
Loading...
